精品久中文字幕人妻_久久亚洲日韩理论AⅤ片_精品日韩二区三区四区_插逼强奸视频中文字幕

|
your current location : home >> News >> Industry Information

Contact UsContact Us

Anshan Carbon Co., Ltd.

Tel: +86-412-8727869

Mrs. Zhao:+86-13478091248

Mr. Wu:+86-18841208011

E-mail: 

            anshantansu@126.com

Website: www.cairollers.com

Sales company address: No. 1, 36th Floor, Junlin Tiansha, 38 Shengli South Road, Tiedong District, Anshan City, Liaoning Province-Anshan Carbon Co., Ltd.


Precautions for graphite electrodes

2019-11-22 11:32:38
Times

1. Wet graphite electrodes should be dried before use. Graphite powder manufacturers

2. Remove the foam protective cap on the spare graphite electrode hole, check whether the internal thread of the electrode hole is complete.

3. Use oil water-free compressed air to clean the surface of the spare graphite electrode the internal thread of the hole; avoid cleaning with steel wire metal brush.

8.jpg

4. Carefully screw the connector into the electrode hole at one end of the spare graphite electrode (it is recommended to directly install the connector into the electrode removed the furnace), do hit the thread.

5. Screw the electrode sling (graphite sling is recommended) into the electrode hole at the other end of the spare electrode.

6. When lifting the electrode, pad a soft object under one end of the spare electrode mounting connector to prevent the ground damaging the connector; use a hook to extend into the hoisting ring of the spreader then lift it. Lift the electrode smoothly to prevent the electrode loosening end B Take off collide with other fixtures.

7. Lift the spare electrode above the electrode to be connected, align it with the electrode hole, then slowly drop it; rotate the spare electrode to make the spiral hook the electrode rotate drop together; when the two electrode ends are 10-20mm apart, use compressed air again Clean the two end faces of the electrode the exposed part of the connector; when the electrode is fully lowered at the end, it should be too strong, otherwise the electrode hole the thread of the connector will be damaged due to a violent collision.

8. Tighten the spare electrode with a torque wrench until the end faces of the two electrodes are in close contact (the correct connection gap between the electrode the connector is less than 0.05mm).

label